Responses (3)

T
Tom_Ring
Hi @user40194. If your Motion Sensor displays the message "Tampered," it means that the cover is not properly seated. This Help Center article [here](https://support.ring.com/hc/en-us/articles/360042653931-Troubleshooting-your-Ring-Alarm-Motion-Detector-2nd-generation-) has some helpful information. This Community post [here](https://community.ring.com/t/how-do-i-clear-a-tamper-message-on-a-motion-detector/357) also addresses a similar concern. Try holding the Tamper switch (above the battery) down for 5 seconds, then releasing and putting the cover back on. Let me know if this helps!
0
•
23-03-2023 19:21:31
•
Reply
U
user44503
I’m having a tamper issue after changing the batteries. I’ve made sure everything fits properly and I also removed it for 5 sec less than an inch away. No soap. The message is still there.
0
•
07-05-2023 13:31:23
•
Reply
J
Justin_Ring
Hi @user44503. If you have tried the steps mentioned in the links Tom provided and are still having the same concern, give our support team a call at one of the numbers available [here](https://support.ring.com/hc/en-us/articles/213608406) for further assistance. If you are outside of the US, please visit [here ](https://support.ring.com/hc/en-gb/articles/213608406)to see how to contact support.
0
•
08-05-2023 16:22:52
•
Reply