Ring Accessories
Browse posts, comment, and join in the discussion about Ring Chime, Chime Pro, and more.
D
Explanation of Access Controller Pro 2 connections needed
access-controller-pro
cs-support
Hi,
Can some explain the individual connections of the terminal block and which ones I should be using?
I need to connect to my gate opener control board which has:
COM - common
OPEN - to open gate
If these are bridged, then the gate opens.
I was expecting the ACP2 to have 2 relay connections
COM - common
NO - normally open
Which would connect directly to my control board
COM to COM
NO to OPEN
The ACP2 terminal block has 8 connections:
Ext:
+5v
Port A:
D1
D0
GND
Port B:
REL1
REL2
Power:
PS1
PS2
Which ones should I connect up to where?
Thanks in advance
Dave
1860 •
1 •
1 •
27-02-2022 13:47:51
Responses (2)
- RIt must be a closely guarded secrete because I'm an electrician and have not been able to find that information anywhere. I have not seen a new unit yet so I don't know if that information is included in the box or not. But I'm not spending $300 to find out. The information on this unit is very hard to find. Even things like how many gates will one unit control? I'm not buying it or suggesting it to any of my clients if I can't find all the information on it.•
2
22-06-2023 17:13:22
•
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
Most Helpful Members
View All
©2024 Ring LLC or its affiliates
Caitlyn_Ring
0
28-02-2022 17:55:41
•