Responses (33)

J
Jdetweiler
I really like the Ring Alarm product and it has allowed me to migrate from a wired ADT system to a homeowner install friendly environment. However, my original wired system allowed me to have 135 degree F heat detectors in the garage and furnace room where a smoke detector is inappropriate. I purchased the retrofit panel in hopes of using it with the Normally Open heat sensors to replace this function. However, I discovered the retrofit kit doesn't accomodate Normally Open circuits. I just placed an order for NC Heat Sensors and hope that it will work with 2K line terminating loads. Regadless, my hope is that Ring will consider adding Heat Detector/Alarms to the product offering.
2
•
12-02-2020 16:10:51
•
Reply
D
dhosk
I've installed the Retro Kit to my Ring Alarm and would like to add my two wired heat sensors to the system. The problem is that my current heat sensors are normally open switches. I’m confident that normally closed heat sensors would work with the Ring Alarm but it would be seen as a door/window. This would cause the police to be dispatched instead of fire should the sensor be tripped. It would be great if hard wired support could be given to both normally open/closed heat sensors including configuration as a heat sensor.
0
•
22-03-2020 21:32:56
•
Reply
M
MarkPr
I would like to see a attic temperature sensor added to the Ring Alarm line. The wired alarm I am replacing has this feature and is a great safety feature since smoke/fire sensors are not recommended for attics due to dust and heat.
0
•
29-04-2020 18:03:30
•
Reply
B
Boone
First Alert Z-Wave Smoke/CO Alarm . . .Doesn't this work for you? It's already available and integrates with the Ring Alarm Base unit seamlessly. https://shop.ring.com/products/first-alert-smoke-co-alarm-zcombo-g-z-wave or if you already have a Smoke/CO alarm, https://shop.ring.com/products/alarm-smoke-co-listener Or were you describing something different?
0
•
22-07-2020 10:52:21
•
Reply
B
Boone
@kazchicago First Alert Z-Wave Smoke/CO Alarm . . .Doesn't this work for you? It's already available and integrates with the Ring Alarm Base unit seamlessly. https://shop.ring.com/products/first-alert-smoke-co-alarm-zcombo-g-z-wave or if you already have a Smoke/CO alarm, https://shop.ring.com/products/alarm-smoke-co-listener Or were you describing something different? You can purchase the Smoke/CO from either Ring or in local stores. First Alert and Ring partnered up together for this feature.
0
•
22-07-2020 11:21:25
•
Reply